Nexx Alarm - NXAL-100 - How to reset your Nexx Alarm device
To reset the device to
factory default, use a
paper clip or
something similar to
press and hold the
reset button until the
green Nexx LED light
starts blinking.
Related Articles
Nexx Alarm - NXAL-100 - Setup and Configuration
1. See the Checklist below before starting A compatible, working alarm system: 1) Check Compatible Alarms 2) Your existing alarm has to be in working condition - that is you can arm/disarm with your alarm code and that there is no periodic beep ...Nexx Alarm - NXAL-100 - Best place to install Nexx Alarm
For good WiFi connection, using the included Velcro tape, attach the Nexx Alarm device on the exterior of the alarm panel enclosure. Note: make sure you have enough space below the Nexx Alarm device in case you need to reset it in the future.Nexx Alarm - NXAL-100 - App Installation & Device Configuration Guide
Please see the attached Nexx Alarm App Installation & Device Configuration Guide on how to set up the Nexx Home app for use with Nexx Alarm and how to configure the Nexx Alarm device.Nexx Alarm - NXAL-100 - Power requirement
The Nexx Alarm device uses 12v power, which is supplied by the alarm panel itself.Nexx Alarm - NXAL-100 - Nexx Alarm Online/Offline Notification
Nexx Alarm will notify you via push notification when the device goes offline/online. The offline message could be either due to a power loss or internet connection loss. Once power or internet is back on, the Nexx Alarm device will reconnect, and ...